What are the causes of heating and scalding during the use of copper foil soft connection?
The product standard should be recognized according to the requirements required by practice, otherwise the copper flexible connection will not only fail to achieve the expected function in the process of use, but may also be damaged. Copper soft connection heating is also a common bad performance. If it is not handled in time, it will simply lead to more serious results. However, in order to effectively avoid the discovery of copper soft connection, the key is to admit what is the reason for this phenomenon, so as to suit the remedy to the case. When planning overcurrent for copper soft connection, it is assumed that the value is too small to reach the equipment conductivity Large current, then simply make it heat; It may also be that the contact holes at both ends of the copper flexible connection are too large or the thickness of the contact surface is different, and the result is the same. Assuming that the contact holes at both ends of copper soft connection are too large, it will not be fully closed, and only part of the contact will not meet the conductive requirements; When the thickness of the contact surface is different, the thinner end will be heated when the overcurrent is applied, making it feel that the whole copper soft connection is heated. When the copper soft connection is used for a long time, its outer protective film will gradually begin to oxidize, showing the phenomenon of heating. In addition, when the equipment is connected with copper soft connection, the wrong position of wiring in and out will also cause poor heat dissipation and heating.
